PDA

View Full Version : Free Z10 has arrived! tune CVEC?



bpcrally
02-26-2004, 04:37 PM
alright my ofna Z10 has arrived, it needs a new belt, and the string in the pullstart is gone, it feels like it rolls a little rough too... it has a CVEC pipe that has not been drilled, where do i drill?:confused:

XXXSRaycer
02-26-2004, 05:19 PM
you should find the appropriate size by going from the samllest one that you think will fit it then until the screw tip fits in snug you stop screw it in and seal it. You should drill the hole on the top. Also how did you get it for free??

-Ryan

rocknbil
02-26-2004, 09:53 PM
... You should drill the hole on the top.

The "top" being any vertical position depending on what angle you want your exhaust pipes to dangle, for example if you prefer your pipes at 45ยบ down, drill it more or less on the top side of that, but err toward the inside of the vehicle.

It should also be somewhere in the first 2/3's of the of the pipe on the engine end of the baffle.

Click here (http://www.nytebyte.com/personal/rides.html) to see how we have our dual and single exhaust CVEC's set up on our GT's.

You know it has an adjustable baffle, right? I love my CVEC's. :D