PDA

View Full Version : Old school! How to make this fit? Rampage truck/car......



thazy2
04-09-2004, 11:33 PM
Hello all.

I have had this truck/car from a while back. It still runs perfect. It was Kyosho first attempt at on road gas car. I believe it was a Corvette ZR-1. Though out the years, it has been modified w/ various parts. The front end was from, I believe, RC10L.


I have tried to use hpi wheel by drilling it out but did not fit so well w/ the bearing. However, the rear fits perfect!


Any suggestions?




Please and thank you.......Jason




Pics: http://www.villagephotos.com/pubbrowse.asp?selected=846178



http://img.villagephotos.com/p/2003-2/105261/PB100601.JPG

lerningdriver
04-10-2004, 01:39 AM
Zip ties and duct tape! lol, jk

you could try replacing the rod that sticks out of the steering knuckle with a threaded one of the same size and put a nut on the end.

RCFUN2
04-10-2004, 09:22 PM
That is a Duratrax conversion for the kyosho rampage. It used the drivetrain and rear suspension of the rampage, and duratrax sold the chassis and you could use any pan car fron end that you wanted. I think RPM used to make a wheel conversion to use touring car wheels on pan cars, if you can get the front wheels from that conversion, it will provably work. If not RPM someother comapany.