PDA

View Full Version : one-way pulley care...



elRey
06-13-2000, 09:59 PM
I just took apart my TAO3r-s for cleaning for the first time (aftering breaking it in).
I notice a little grease on the gear shaft where I have a one-way bearing. I did not grease the bearing or the shaft since the installation instruction didn't call for it.
Is this pre-installed grease from the bearing that I need to replace??

What steps should I take to keep the one-way working smoothly?

Thanks,

Rey

SteveP
06-14-2000, 08:42 AM
As long as there's no gritty feeling in the one-way bearing, I would suggest leaving it alone. If there is, clean it with some motor spray, let it dry completely, then pack some diff lube in the bearing prior to installation.

elRey
06-14-2000, 11:46 AM
I appreciate the help SteveP

Rey