View Full Version : how "tall" have you geared your rc10gt????

08-09-2007, 03:51 PM
Just curious, I just came in form running 24/66.:eek:

I blued my new c/b in about 6-7 runs, still havent seen top speed due to the NARROW street I live on. (I got skeered:roll2:)

I did have to hack and slash my chassis to get this set up.

Anyone else go this far or farther?


08-09-2007, 05:39 PM
Associated's Nitro Dual Sports 2wd touring car from the 2nd half of the 90s could accept a 24/54. They used tires slightly taller than standard TC tires, but the chassis was identical to the tub chassis GT (except about 1/2" IIRC was trimmed from the front where the kick-up plate bolted to the chassis) and the transmission was the Stealth 2.6.

I don't know how this crosses over to the blue chassises though. I'm assuming you had to do some grinding to slide the engine forward; with the smaller spur and the 24t cb, you might not have to do anything. Heres the spur from RRP: http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXEY69&P=7 .

Its a matter of time until Toyotatogo chimes in with his .21 GT...

08-09-2007, 06:46 PM
I knew about the smaller spurs, but just wanted to slap it together and see if it would melt the spur.:D

I have the mip 4in1 reversed and with weights, probably will turn it around and see if this give me any more grip.

Thanks for your reply,


08-10-2007, 04:43 AM
got a 3 times driven-3 times crashed rc10 from a garbage sale...and anyways after dialing it in it freekin screams on open land. keeps my 1/8 on road a honest. about 45 mph stock gears

08-13-2007, 10:05 PM
ahh the good ole days .... I need a new motor for my truck it's been ages since I've ran it though ..