Latest from MIP:

“MIP Pucks™” ‘ARE’ the future of 17.5 stock racing! MIP’s all new Puck™ Drive system is an aluminum based drivetrain system which includes aluminum diff outdrives, aluminum C-CVD™ bones, and replaceable plastic orange wear Pucks that take the place of inferior steel pins. This combination greatly increases the longevity of the drivetrain and most importantly decreases the drivetrain’s overall rotating mass by a whopping 50%! The decrease in weight directly results in quicker acceleration, deceleration, and lower motor temps! Get the advantage that every stock racer craves! GET, MIP’s all new Hard Anodized 7075-T6 Aluminum Puck™ drive system!

TARGET CUSTOMERS:

17.5 Stock Racers

COMPETITIVE ADVANTAGES:

  • Less rotating mass
  • Quicker acceleration
  • Quicker deceleration
  • Lower motor temps
  • Less overall wear on drive components


FEATURES:

  • Complete MIP Differential (Minus Diff Gear)
  • Complete C-CVD™ Axle Set
  • 50% less rotating mass over stock steal components
  • Replaceable Pucks to keep your drivetrain fresh
  • Two sets of holes in the C-CVD™ bell
  • Hard Anodized 7075-T6 Aluminum
  • Race proven C-CVD™ Construct
  • 100% Quality made in the USA!


INCLUDES:

MIP C-CVD™ Alum. Bone (2), MIP Female Outdrive (1), MIP Male Outdrive (1), MIP CVD™ Axle (2), MIP Confetti Sticker (2), MIP Inst. Sheet (1), MIP Thread Gel Safety (1), MIP Lube & Thread Gel Cup (1), Diff Lube & Grease Cup (1). MIP Thrust Cover (1), Molded T-Nut (1), 2-56 x .925 Diff Screw Shoulder (1), Ľ x 9/32” Diff Spring (1), Hardened #2 Washer (1), MIP Modified Diff Ring (2), 1/16 Ch. Steel Ball Bearing (7), 3/32” Ch. Steel Ball Bearing (14), 1-72 x 1/8 Button Head Cap Screw (6), MIP Outdrive Puck (8), MIP CVD™ Puck Pin (2), MIP Retaining Ring (2), MIP 3/16 CVD™ Coupling (2), M4 x .7mm Steel Locknut (2), 1/16” x 3/8” Roll Pin (2), 1/16” x .430” Solid Pin (2), 4-40 x 3/32” Cup Point (2)

REQUIRES:

.050 Allen Key – (Suggest - #9000 MIP Hex Driver Wrench .050 inch)
2.0mm Allen Key- (Suggest - #9008 MIP Hex Driver Wrench 2.0mm)

COMPATIBILITY:

TLR22 2.0 (#TLR03003)

#15030 - MSRP: $95.00